3 4 36 spline input shaft.
Mustang ii rack and pinion high pressure port.
Work out your hose routing and decide where to use each hose end extra hose ends and hose are available.
The pressure line in this kit has a 5 8 18 male inverted flare fitting at the power steering pump end along with a 6an to an 9 16 18 14mm 1 5 male o ring fitting on the rack end.
Transfer the check valve to the replacement unit.
Chevy which has a chevy pump with a mustang power rack pinion.
The kit comes with 90ohose ends.
The return port is m16 1 5 o ring.
Stan the small port is high pressure big port is low pressure.
This set adapts an aftermarket 1982 1988 t bird cougar type rack or our 91034340 pow rack to a gm style pump.
Check here for special coupons and promotions.
The original rack pinion may have a removable check valve in the pressure port.
This power rack has a v style input shaft and uses the same tie rod ends as the mustang ii rack.
Help identify this rackpostssep 2010rack and pinion line connections.
Uses 910 4047 6an adapter fittings.
Replacement sku for rack and pinion hard lines is 910 35344.
Refer to protech 22 0010 for more information.
Order rack pinion complete unit for your 1978 ford mustang ii and pick it up in store make your purchase find a store near you and get directions.
Use the figures above to determine the correct port for the check valve.
The high pressure fitting is the m14x1 5 thread port which is toward the front of the rack and the return fitting is m16x1 5 thread port that is at the rear closest to the pinion input shaft.
This video explains plainly which port on the mustang fox body and sn 95 rack and pinions are the high pressure port and which is the low pressure return port.
The pressure port in the rack is the 1 2 20 port.
Must use offset bushings 910 34342 to mount to original mustang ii crossmembers.
Begin the installation by assembling the proper adapters into the pump and rack pinion.
Your order may be eligible for ship to home and shipping is free on all online orders of 35 00.
Return hose will normally need to be cut to length.
Rack has 9 16 18 female o ring high pressure inlet and 5 8 18 female o ring low pressure outlet return line threaded ports.
